Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the heated oxygen sensor removal/installation are shown below.
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replacement Part |
Necessary Procedure |
Effect/Inoperative Function when Necessary Procedures are not Performed |
Link |
| Heated oxygen sensor |
Inspection after repair |
- Poor idle, etc.
- Engine start function, etc.
|
Refer to INITIALIZATION [07/2020 - ] |
- Position control ECU assembly LH (Including removal and installation)
- Position control ECU assembly RH (Including removal and installation)
- Power seat switch LH (Including removal and installation)
- Power seat switch RH (Including removal and installation)
- Front seatback frame sub-assembly LH (Including removal and installation)
- Front seatback frame sub-assembly RH (Including removal and installation)
- Front seat adjuster assembly LH (Including removal and installation)
- Front seat adjuster assembly RH (Including removal and installation)
- Power seat tilt motor assembly LH (Including removal and installation)
- Power seat tilt motor assembly RH (Including removal and installation)
- Power seat lifter motor assembly LH (Including removal and installation)
- Power seat lifter motor assembly RH (Including removal and installation)
|
Initialize position control ECU |
Front Power Seat Control System |
Refer to REGISTRATION [07/2020 - ] |
- Front seat assembly RH (Only for removal and installation)
- Occupant detection ECU (Including removal and installation)
|
Zero point calibration (Occupant classification system) |
- Occupant classification system
- Passenger airbag ON/OFF indicator
- Airbag system (Front passenger side)
- Seat belt warning system (Front passenger)
|
Refer to INITIALIZATION [07/2020 - ] |