Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Lexus >> 2021 >> ES 300h Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Engine Control System (A25A-FKS) - Service Information) >> Active Control Engine Mount >> Installation [08/2020 - ] >> Procedure

Installation [08/2020 - ]: Procedure

WARNING: This page is about a different car, the 2024 Lexus ES 250, 2023 Lexus ES 250, 2022 Lexus ES 250, and 2021 Lexus ES 250. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL FRONT ENGINE MOUNTING INSULATOR 
    1. Install the stay to the front engine mounting insulator with the nut.

      Torque: 6.0 N.m (61 kgf/cm, 53 in.lbf) 

    2. Install the front engine mounting insulator to the front frame assembly with the 3 nuts.

      Torque: 72 N.m (734 kgf/cm, 53 ft.lbf) 

    3. Install the front engine mounting bracket to the transaxle housing with the 3 bolts.
      GTY948686Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Bolt (A), (B) and (C) 

      Torque: 42 N.m (428 kgf/cm, 31 ft.lbf) 

      NOTE:

      Temporarily tighten the bolt (A), and then fully tighten the 3 bolts in the order of (B), (C) and (A).

    4. Install the front engine mounting bracket to the front engine mounting insulator with the bolt.

      Bolt (D) 

      Torque: 72 N.m (734 kgf/cm, 53 ft.lbf) 

    5. Install the vacuum hose to the front engine mounting insulator.
    6. Engage the 2 clamps to install the vacuum hoses to the front engine mounting insulator.
    7. Install the No. 1 radiator bracket to the front engine mounting bracket with the bolt.

      Torque: 19 N.m (194 kgf/cm, 14 ft.lbf) 

    8. Engage the 4 clamps to install the radiator hose, vacuum hoses and No. 2 engine wire to the No. 1 radiator bracket.
  2. INSTALL SUSPENSION TOWER DAMPER (w/ Performance Damper) 

    Refer to PROCEDURE - Step 1

  3. INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY 

    Refer to PROCEDURE - Step 71 [08/2020 - 08/2021] , or refer to PROCEDURE - Step 72 [08/2021 - ]

  4. INSTALL NO. 1 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 72 [08/2020 - 08/2021] , or refer to PROCEDURE - Step 73 [08/2021 - ]

  5. INSTALL FRONT WHEEL OPENING EXTENSION PAD LH 

    Refer to PROCEDURE - Step 73 [08/2020 - 08/2021] , or refer to PROCEDURE - Step 74 [08/2021 - ]

  6. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH 

    Refer to PROCEDURE - Step 74 [08/2020 - 08/2021] , or refer to PROCEDURE - Step 75 [08/2021 - ]

  7. INSTALL VACUUM SWITCHING VALVE (for Active Control Engine Mount System) 

    Refer to INSTALLATION [08/2020 - ] 

scientia non olet · About Mike's Workshop Manuals