Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during engine coolant temperature sensor removal/installation are shown below.
NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Auxiliary battery terminal is disconnected/reconnected | Perform steering sensor zero point calibration | Lane Tracing Assist System | Refer to INITIALIZATION [08/2021 - ] |
| Pre-collision System | |||
| Parking Support Brake System* | |||
| Lighting System (for HV Model) | |||
| Initialize power trunk lid system | Power Trunk Lid System (for HV Model) | Refer to INITIALIZATION [06/2018 - ] | |
| Replacement of inverter with converter assembly | Resolver learning |
|
Refer to UTILITY [06/2018 - ]
for Nickel Metal Hydride Battery Refer to UTILITY [08/2020 - ] for Lithium-ion Battery |
| Replacement of ECM | Perform Vehicle Identification Number (VIN) registration | MIL illuminates | Refer to REGISTRATION [06/2018 - ] |
| Replacement of engine coolant temperature sensor | Inspection after repair |
|
Refer to INITIALIZATION [08/2021 - ] |
*: When performing learning using the Techstream.
NOTE:
- After the ignition switch is turned off, the audio and visual system records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 2 minutes before disconnecting the cable from the negative (-) auxiliary battery terminal.
- When the cable is disconnected from the negative (-) auxiliary battery terminal and the security lock setting has been enabled, multi-display operations will be disabled upon next startup unless the password is entered. Be sure to check the security lock setting before disconnecting the cable from the negative (-) auxiliary battery terminal.