Installation [06/2018 - ]: Procedure
- INSTALL ABSORBER CONTROL ECU
- Install the absorber control ECU with the 2 nuts.
Torque: 7.5 N.m (76 kgf/cm, 66 in.lbf)
NOTE:- Avoid any impact to the absorber control ECU.
- Do not drop the absorber control ECU. If it is dropped, replace it with a new one.
- Connect the 2 connectors to the absorber control ECU.
- Install the absorber control ECU with the 2 nuts.
- INSTALL LUGGAGE COMPARTMENT TRIM INNER COVER RH
Refer to PROCEDURE - Step 10 [06/2018 - 08/2021] , or refer to PROCEDURE - Step 10 [08/2021 - ]
- INSTALL LUGGAGE COMPARTMENT TRIM COVER RH
Refer to PROCEDURE - Step 12 [06/2018 - 08/2021] , or refer to PROCEDURE - Step 12 [08/2021 - ]
- INSTALL REAR FLOOR FINISH PLATE
Refer to PROCEDURE - Step 13 [06/2018 - 08/2021] , or refer to PROCEDURE - Step 13 [08/2021 - ]
- INSTALL SPARE WHEEL COVER TRAY
Refer to PROCEDURE - Step 14 [06/2018 - 08/2021] , or refer to PROCEDURE - Step 14 [08/2021 - ]
- INSTALL LUGGAGE COMPARTMENT FLOOR MAT
Refer to PROCEDURE - Step 15 [06/2018 - 08/2021] , or refer to PROCEDURE - Step 15 [08/2021 - ]
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Refer to PROCEDURE - Step 2
NOTE:When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Refer to INITIALIZATION [06/2018 - 10/2019] , or refer to INITIALIZATION [10/2019 - 08/2020] , or refer to INITIALIZATION [08/2020 - 08/2021] , or refer to INITIALIZATION [08/2021 - 09/2022] , or refer to INITIALIZATION [09/2022 - ]
- PERFORM TEST MODE PROCEDURE NOTE:
After replacing the absorber control ECU, it is necessary to perform registration of vehicle identification information. Vehicle identification information is automatically acquired when the system enters test mode.
Refer to TEST MODE PROCEDURE [06/2018 - 08/2021] , or refer to TEST MODE PROCEDURE [08/2021 - ]