Customize Parameters [01/2017 - 04/2020]

CUSTOMIZE FRONT POWER SEAT CONTROL SYSTEM

HINT:

The following items can be customized.

NOTE:

When the customer requests a change in a function, first make sure that the function can be customized.
Record the current settings before customizing.

Customizing with the Techstream

Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Customize Setting / Seat.

Select the setting by referring to the table below.

Seat

Tester Display	Description	Default	Setting	ECU
Driver Seat Slide Link Hdrest Length Ctrl	Function to the physique compensation headrest control when driver seat is slide (for Standard Seat Type)	Avail	0:Avail, 1:Not Avl	Position control ECU assembly LH
Passenger Seat Slide Link Headrest Length Control	Function to the physique compensation headrest control when front passenger seat is slide (for Standard Seat Type)	Avail	0:Avail, 1:Not Avl	Position control ECU assembly RH
D Seat Operation Interference Avoidance Function	Setting of the function to reverse operation when jam detection is detected during slide direction driver seat	ON	0:ON, 1:OFF	Position control ECU assembly LH
P Seat Operation Interference Avoidance Function	Setting of the function to reverse operation when jam detection is detected during slide direction front passenger seat	ON	0:ON, 1:OFF	Position control ECU assembly RH

Enter the following menus: Customize Setting / Smart Key/ Access.

Select the setting by referring to the table below.

Smart Key / Access

Tester Display	Description	Default	Setting	ECU
Seat position/Tilt & Telesco memory recall setting	This customize function switches the condition of the seat position and Tilt & Telesco memory recall. Possible recall activation parameter "D-door unlock and open by smart system" or "Any door unlock and open with smart system".	D Door	0:D Door, 1:Any Door	Main body ECU (Multiplex network body ECU)