Removal [08/2019 - ]: Procedure
- PRECAUTION NOTE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Refer to PRECAUTION [08/2019 - ]
- REMOVE DECK BOARD ASSEMBLY (w/o Rear No. 2 Seat)
Refer to PROCEDURE - Step 2
- REMOVE REAR DECK FLOOR BOX (w/o Rear No. 2 Seat)
Refer to PROCEDURE - Step 4
- REMOVE REAR NO. 4 FLOOR BOARD (w/ Rear No. 2 Seat)
Refer to PROCEDURE - Step 3
- REMOVE BATTERY SERVICE HOLE COVER (w/ Rear No. 2 Seat)
Refer to PROCEDURE - Step 4
- DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
w/o Rear No. 2 Seat: Refer to PROCEDURE - Step 4 [08/2019 - ]
w/ Rear No. 2 Seat: Refer to PROCEDURE - Step 5 [08/2019 - ]
- REMOVE FRONT DOOR SCUFF PLATE RH
HINT:
Use the same procedure as for the LH side.
w/o Rear No. 2 Seat: Refer to PROCEDURE - Step 9 [08/2019 - ]
w/ Rear No. 2 Seat: Refer to PROCEDURE - Step 11 [08/2019 - ]
- REMOVE COWL SIDE TRIM BOARD RH
HINT:
Use the same procedure as for the LH side.
Refer to PROCEDURE - Step 3
- REMOVE INSTRUMENT PANEL GARNISH RH
Refer to PROCEDURE - Step 20
- REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 23
- REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
Refer to PROCEDURE - Step 3
- REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY
Refer to PROCEDURE - Step 24
- REMOVE SKID CONTROL ECU ASSEMBLY