Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Lexus >> 2017 >> LS 460 Base, AWD >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Control System - Service Information >> Camshaft Timing Control Motor >> On-Vehicle Inspection [09/2015 - ] >> Procedure

On-Vehicle Inspection [09/2015 - ]: Procedure

  1. INSPECT FUNCTION OF CAMSHAFT TIMING CONTROL WITH EDU MOTOR ASSEMBLY 
    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG) and turn the tester on.
    3. Start the engine and warm it up.
    4. Engine is idling.
    5. Enter the following menus: Powertrain / Engine / Active Test / Control the VVT-iE Linear (Bank 1) or Control the VVT-iE Linear (Bank 2) / All Data / VVT-iE Aim Angle #1* and VVT Change Angle #1* or VVT-iE Aim Angle #2* and VVT Change Angle #2*.
    6. Perform the Active Test operation with the engine speed at 1500 rpm.

      OK

      Active Test Movement Order Difference between "VVT-iE Aim Angle" and "VVT Change Angle"
      0 deg → 10 deg → 20 deg → 40 deg → 10 deg → 0 deg → 10 deg → END Within 4 DegFR

      HINT: 

      If not within the standard, inspect the camshaft timing control with EDU motor assembly and camshaft timing gear assembly (Refer to INSPECTION [09/2015 - ] ).

scientia non olet · About Mike's Workshop Manuals