How To Proceed With Troubleshooting [09/2015 - ]: Procedure

Result

Result:  1

NEXT 

See step  2

Result

Result:  1

NEXT 

See step  3

1. Measure the battery voltage with the engine switch off.

   Standard Voltage

   11 to 14 V

   HINT: 

   If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.

   Result

   Proceed to
   NEXT

Result:  1

NEXT 

See step  4

1. Use the Techstream to check if the CAN communication system is functioning normally.

   Refer to HOW TO PROCEED WITH TROUBLESHOOTING [09/2015 - ]

   Result

   Result	Proceed to
   CAN DTC is not output	A
   CAN DTC is output	B

Result:  2

B 

GO TO CAN COMMUNICATION SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [09/2015 - ] 

Result:  1

A 

See step  5

1. Clear the DTCs.

   Refer to DTC CHECK / CLEAR [09/2015 - ] 

2. Recheck for DTCs.

   Refer to DTC CHECK / CLEAR [09/2015 - ] 

   1. Attempt to reproduce malfunction symptoms according to the recorded DTCs and check if the DTCs are stored again.

   Result

   Result	Proceed to
   DTC is not output	A
   DTC is output	B

Result:  2

B 

GO TO DIAGNOSTIC TROUBLE CODE CHART. Refer to  DIAGNOSTIC TROUBLE CODE CHART [09/2015 - ]  

Result:  1

A 

See step  6

1. Refer to Problem Symptoms Table.

   Refer to PROBLEM SYMPTOMS TABLE [09/2015 - ] 

   Result

   Result	Proceed to
   Fault is not listed in problem symptoms table	A
   Fault is listed in problem symptoms table	B

Result:  2

B 

ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE 

Result:  1

A 

See step  7

1. Check Data List / Active Test

   Refer to DATA LIST / ACTIVE TEST [09/2015 - ] 

2. Check Terminals of ECU

   Refer to TERMINALS OF ECU [09/2015 - ] 

   Result

   Proceed to
   NEXT

Result:  1

NEXT 

See step  8

Result

Result:  1

NEXT 

See step  9

Result

Result:  1

NEXT 

END