On-Vehicle Inspection [10/2015 - ]: Procedure

HINT: 

Perform "Inspection After Repair" after replacing the mass air flow meter sub-assembly.

Refer to INITIALIZATION [10/2015 - ]

1. Read the value using the Techstream (MAF).
   NOTE:

   Perform the inspection of the mass air flow meter sub-assembly while it is installed to the air cleaner cap sub-assembly (installed to the vehicle).

   1. Connect the Techstream to the DLC3.
   2. Start the engine.
   3. Turn the Techstream on.
   4. Enter the following menus: Powertrain / Engine / Data List / MAF.

      Powertrain > Engine > Data List 

      Tester Display
      MAF

   5. Wait for 30 seconds, and read the value on the Techstream.

      Standard Condition

      Tester Display	Condition	Specified Condition
      MAF	Idling	4.0 to 7.0 gm/sec
      	2000 rpm	12.0 to 16.0 gm/sec
      	3000 rpm	17.0 to 23.0 gm/sec

      If the result is not as specified, replace the mass air flow meter sub-assembly.

      If the result is within the specified range, inspect the mass air flow meter sub-assembly.

      Refer to INSPECTION [10/2015 - ] 

1. Perform "Inspection After Repair" after replacing the mass air flow meter sub-assembly.

   Refer to INITIALIZATION [10/2015 - ]