Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Lexus >> 2017 >> GS 350 Base, AWD >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Control System - Service Information >> Mass Air Flow Meter >> On-Vehicle Inspection [10/2015 - ] >> Procedure

On-Vehicle Inspection [10/2015 - ]: Procedure

  1. INSPECT INTAKE MASS AIR FLOW METER SUB-ASSEMBLY 
    1. Read the value using the Techstream.
      NOTE:
      • Turn off the engine.
      • Perform the inspection with the vehicle indoors and on a level surface.
      • Perform the inspection of the intake mass air flow meter sub-assembly while it is installed to the air cleaner case (installed to the vehicle).
      • During the test, do not use the exhaust air duct to perform suction on the exhaust pipe.
      1. Turn the engine switch on (IG) (do not run the engine).
      2. Turn the Techstream on.
      3. Enter the following menus: Powertrain / Engine / Data List / Mass Air Flow Sensor.
      4. Wait 30 seconds and read the value on the Techstream.

        Standard Condition

        Item Condition Specified Condition
        MAF
        • Engine not running
        • 30 seconds after turning engine switch on
        		 0.57 g/sec or less

        If the result is not as specified, replace the intake mass air flow meter sub-assembly.

        If the result is within the specified range, inspect the intake mass air flow meter sub-assembly.

        Refer to INSPECTION [10/2015 - ] 

scientia non olet · About Mike's Workshop Manuals