Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Lexus >> 2017 >> CT 200h Base >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Control System - Service Information >> Air Fuel Ratio Sensor >> Removal [08/2014 - ] >> Procedure

Removal [08/2014 - ]: Procedure

  1. REMOVE WINDSHIELD WIPER MOTOR AND LINK 

    (See article. Refer to REMOVAL [08/2014 - ] )

  2. REMOVE NO. 1 HEATER AIR DUCT SPLASH SHIELD SEAL 

    Refer to PROCEDURE - Step 4

  3. REMOVE NO. 2 HEATER AIR DUCT SPLASH SHIELD SEAL 

    Refer to PROCEDURE - Step 5

  4. REMOVE COWL BODY MOUNTING REINFORCEMENT LH 

    Refer to PROCEDURE - Step 6

  5. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 7

  6. REMOVE NO. 2 CYLINDER HEAD COVER 

    Refer to PROCEDURE - Step 20

  7. REMOVE AIR FUEL RATIO SENSOR 
    1. Disconnect the air fuel ratio sensor connector and clamp.
      GTY328869Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Using SST, remove the air fuel ratio sensor.
      GTY340784Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      • SST: 09224-00010 
scientia non olet · About Mike's Workshop Manuals