Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Lexus >> 2017 >> CT 200h Base >> Repair and Diagnosis >> Electrical >> Starter >> Power Switch (Starting System) - Service Information >> Power Switch >> Inspection [08/2014 - ] >> Procedure

Inspection [08/2014 - ]: Procedure

  1. INSPECT POWER SWITCH 
    1. Measure the resistance according to the value(s) in the table below.
      GTY217710Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Standard Resistance

      Tester Connection Switch Condition Specified Condition
      7 (SS1) - 5 (GND) Pushed Below 1 Ω
      2 (SS2) - 5 (GND) Pushed Below 1 Ω
      7 (SS1) - 5 (GND) Not pushed 10 kΩ or higher
      2 (SS2) - 5 (GND) Not pushed 10 kΩ or higher

      If the result is not as specified, replace the power switch.

    2. Apply battery voltage between the terminals of the switch, and check the illumination condition of the power switch.
      GTY530799Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      TEXT IN ILLUSTRATION

      *a Indicator Light *b Power Switch Illumination

      Standard Resistance

      Measurement Condition Specified Condition
      Auxiliary battery positive (+) →Terminal 11 (SWIL)
      Auxiliary battery negative (-) →Terminal 4 (COM) or 5 (GND)      		 Illuminates
      (Power Switch Illumination)
      Auxiliary battery positive (+) →Terminal 12 (INDS)
      Auxiliary battery negative (-) →Terminal 4 (COM) or 5 (GND)      		 Illuminates
      (Indicator Light)
      Auxiliary battery positive (+) →Terminal 13 (INDW)
      Auxiliary battery negative (-) →Terminal 4 (COM) or 5 (GND)      		 Illuminates
      (Indicator Light)

      If the result is not as specified, replace the power switch.

scientia non olet · About Mike's Workshop Manuals