Removal [09/2015 - ]: Procedure
- PRECAUTION NOTE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work (Refer to PRECAUTION [09/2015 - ] ).
- REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY
Refer to PROCEDURE - Step 3
- REMOVE BATTERY SERVICE HOLE COVER LH
Refer to PROCEDURE - Step 4
- DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL WARNING:
Wait at least 90 seconds after disconnecting the cable from the auxiliary battery negative (-) terminal to disable the SRS system.
NOTE:When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [09/2015 - ] ).
- REMOVE ROPE HOOK ASSEMBLY
Refer to PROCEDURE - Step 6
- REMOVE ROPE HOOK
Refer to PROCEDURE - Step 5
- REMOVE DECK TRIM SIDE BOARD RH
Refer to PROCEDURE - Step 7
- REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY
Refer to PROCEDURE - Step 8
- REMOVE NO. 1 COOLER COVER
Refer to PROCEDURE - Step 14
- REMOVE FRONT LUGGAGE COMPARTMENT TRIM COVER
Refer to PROCEDURE - Step 10
- REMOVE REAR FLOOR FINISH PLATE
Refer to PROCEDURE - Step 11
- REMOVE LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY LH
Refer to PROCEDURE - Step 12
- REMOVE SEAT VIBRATOR MODULE ASSEMBLY (for Ottoman)
Refer to PROCEDURE - Step 11
- REMOVE SEAT BELT CONTROL ECU
- Disconnect the 2 connectors.
- Remove the 2 nuts and seat belt control ECU.