Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Lexus >> 2016 >> GS 450h Base >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> Cruise Control System (Service Information) >> Cruise Control Main Switch >> Removal [09/2014 - 10/2015] >> Procedure

Removal [09/2014 - 10/2015]: Procedure

  1. PRECAUTION 
    NOTE:

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work (See article. Refer to PRECAUTION [09/2014 - 10/2015] ).

  2. REMOVE LUGGAGE COMPARTMENT FLOOR MAT 

    Refer to PROCEDURE - Step 1

  3. REMOVE LUGGAGE COMPARTMENT TRIM COVER LH 

    Refer to PROCEDURE - Step 2

  4. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL 
    WARNING:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See article. Refer to INITIALIZATION [09/2014 - 10/2015] ).

  5. REMOVE LOWER NO. 3 STEERING WHEEL COVER 

    Refer to PROCEDURE - Step 5

  6. REMOVE LOWER NO. 2 STEERING WHEEL COVER 

    Refer to PROCEDURE - Step 6

  7. REMOVE STEERING PAD 

    Refer to PROCEDURE - Step 7

  8. REMOVE CRUISE CONTROL MAIN SWITCH 
    1. Detach the clamp.
      GTY397469Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disconnect the connector.
    3. Remove the 2 screws and cruise control main switch.
      GTY397470Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About Mike's Workshop Manuals