Inspection [09/2014 - 10/2015]: Procedure

INSPECT FUEL DELIVERY PIPE SUB-ASSEMBLY (FUEL PRESSURE SENSOR)

NOTE:

Do not remove the fuel pressure sensor from the fuel delivery pipe sub-assembly.
If a fuel pressure sensor is removed, replace the fuel delivery pipe sub-assembly (fuel pressure sensor) with a new one.

Check the fuel pressure sensor output voltage.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Apply 5 V between terminals 3 (VC) and 1 (E2).

TEXT IN ILLUSTRATION

*a	Component without harness connected (Fuel Pressure Sensor)
*b	Voltage applied bet ween terminals

NOTE:

Be careful when connecting the leads, as the fuel pressure sensor may be damaged if the leads are connected to the wrong terminals.
Do not apply 6 V or more of voltage to terminals 3 (VC) and 1 (E2).

HINT:

If a stable power supply is not available, use 4 1.2 V nickel-metal hydride batteries, etc.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Measure the voltage between terminals.

Standard Voltage

Tester Connection	Condition	Specified Condition
2 (PR) - 1 (E2)	Pressure not applied to fuel pressure sensor	Approximately 0.5 V*

*: The output voltage changes depending on the voltage applied to the terminals.

Output voltage = (0.1 x Voltage applied to terminals)

TEXT IN ILLUSTRATION

*a	Component without harness connected (Fuel Pressure Sensor)

If the result is not as specified, replace the fuel delivery pipe sub-assembly (fuel pressure sensor).