Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Lexus >> 2013 >> LS 460 Base, AWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System (Service Information) >> Accelerator Pedal >> On-Vehicle Inspection [09/2012 - ] >> On-Vehicle Inspection [09/2012 - ]

On-Vehicle Inspection [09/2012 - ]

  1. INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY 
    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the tester on.
    4. Enter the following menus: Powertrain / Engine / Data List / ETCS / Accel Sensor Out No. 1 and Accel Sensor Out No. 2.
    5. Read the value displayed on the tester.

      Accel Sensor Out No. 1 Standard Voltage

      Condition Specified Condition
      Accelerator pedal is released 0.5 to 1.1 V
      Accelerator pedal is depressed 2.6 to 4.5 V

      Accel Sensor Out No. 2 Standard Voltage

      Condition Specified Condition
      Accelerator pedal is released 1.2 to 2.0 V
      Accelerator pedal is depressed 3.4 to 4.75 V

      If the result is not as specified, check the accelerator pedal sensor assembly, wire harness or ECM.

scientia non olet · About Mike's Workshop Manuals