DTC B22AE: Open in Alternater Charge Line: Procedure

1. Check the generator's tightening torque value.

   Standard torque

   Generator	Standard torque
   Terminal 1 (B)	12 N*m (122 kgf*cm, 8.82 ft.*lbf)

NG → TIGHTEN GENERATOR ASSEMBLY (TERMINAL B) 

OK: Go to next step 

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Disconnect the E24 generator connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard voltage

   Tester Connection	Switch Condition	Specified Condition
   E24-2 (IG) - Body ground	Engine switch on (IG)	11 to 14 V

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → REPLACE PASSENGER SIDE JUNCTION BLOCK (ELECTRIC POWER CONTROL ECU)