Installation [09/2012 - ]

NOTE:

While the battery is connected, even if the engine switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal and open/close the doors while the battery is connected.

INSTALL STEERING ANGLE SENSOR
1. Align the pins on the spiral cable with the installation holes on the steering sensor.
  
  Fig 1: Aligning Spiral Cable Pins
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  TEXT IN ILLUSTRATION
  
  *1 Pin
2. Attach the 6 claws and install the spiral cable to the steering sensor.
INSTALL SPIRAL CABLE SUB-ASSEMBLY . Refer to INSTALLATION [09/2012 - ] - Step 2
INSTALL STEERING COLUMN COVER
1. w/ VGRS:
  Refer to INSTALLATION [09/2012 - ]
2. w/o VGRS:
  Refer to INSTALLATION [09/2012 - ]
ADJUST SPIRAL CABLE SUB-ASSEMBLY . Refer to INSTALLATION [09/2012 - ] - Step 5
INSTALL STEERING WHEEL ASSEMBLY
Refer to INSTALLATION [09/2012 - ]
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
- Reset the AUTO TILT AWAY function setting to the previous condition by changing the customize parameter. Refer to CUSTOMIZE PARAMETERS [09/2012 - ] .
- When reconnecting the cable to the negative battery terminal after installing the steering sensor, check that the front tires and steering wheel are kept aligned straight ahead before and after connecting the cable to the negative battery terminal.
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION [09/2012 - ] .
INSTALL COWL TOP VENTILATOR LOUVER RH . Refer to INSTALLATION [09/2012 - ] - Step 17
INSPECT STEERING PAD . Refer to INSTALLATION [09/2012 - ] - Step 5
CHECK SRS WARNING LIGHT
Refer to DIAGNOSIS SYSTEM [09/2012 - ]