Cruise SET Indicator Light Circuit: Procedure
- PERFORM ACTIVE TEST USING TECHSTREAM (SET INDICATOR LIGHT)
- Select the Active Test, use the Techstream to generate a control command, and then check that the combination meter operates. Refer to DATA LIST / ACTIVE TEST [09/2012 - ]
.COMBINATION METER
Tester Display Test Part Control Range Diagnostic Note Indicat. SET Cruise control SET indicator light ON / OFF - OK
Indicator light turns on.
NG → See step 4
OK: Go to next step
- Select the Active Test, use the Techstream to generate a control command, and then check that the combination meter operates. Refer to DATA LIST / ACTIVE TEST [09/2012 - ]
.
- READ VALUE USING TECHSTREAM (SET/COAST SWITCH)
- Check the Data List for proper functioning of the SET indicator light. Refer to DATA LIST / ACTIVE TEST [09/2012 - ]
.RADAR CRUISE
Tester Display Measurement Item/Range Normal Condition Diagnostic Note SET/COAST Switch -/SET switch signal / ON or OFF ON: -/SET switch on
OFF: -/SET switch off- OK
On screen, each item changes between ON and OFF according to above chart.
NG → See step 5
OK → See step 3
- Check the Data List for proper functioning of the SET indicator light. Refer to DATA LIST / ACTIVE TEST [09/2012 - ]
.
- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to PROBLEM SYMPTOMS TABLE [09/2012 - ]
- GO TO METER / GAUGE SYSTEM. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [09/2012 - ]
- REPLACE ECM. Refer to REMOVAL [09/2012 - ]