Slip Indicator Light Remains ON: Procedure

1. Check if a CAN communication system DTC is output. Refer to DIAGNOSIS SYSTEM [08/2012 - ] .

   Result

   Result	Proceed to
   DTC is not output	A
   DTC is output	B

B → See step   7 

A: Go to next step 

1. Check if a multiplex communication system DTC is output. Refer to DTC CHECK / CLEAR [08/2012 - ] .

   Result

   Result	Proceed to
   DTC is not output	A
   DTC is output	B

B → See step   9 

A: Go to next step 

1. Check if the skid control ECU connector is securely connected.

   OK

   The connector is securely connected.

NG → CONNECT CONNECTOR TO ECU CORRECTLY 

OK: Go to next step 

1. Check the battery voltage.

   Standard Voltage

   11 to 14 V

NG → See step   10 

OK: Go to next step 

1. Perform the Active Test of the combination meter (meter CPU) using the Techstream. Refer to DATA LIST / ACTIVE TEST [08/2012 - ] .
2. Check the combination meter.

   OK

   The slip indicator light turns on or off in accordance with the Techstream operation.

   HINT: 

   If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the part. Refer to PROBLEM SYMPTOMS TABLE [08/2012 - ] .

NG → See step   8 

OK → See step   6