DTC P1630: Communication Error from VSC to ECM: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Clear the DTCs. Refer to DTC CHECK/CLEAR [08/2012 - ] .
5. Perform the following to make sure that the DTC detection conditions are met.

   HINT: 

   If the detection conditions are not met, the malfunction cannot be detected.

   1. Drive the vehicle at a speed of 50 km/h (30 mph) or more.
   2. Turn the cruise control main switch on.
6. Enter the following menus: Powertrain / Radar Cruise / Trouble Codes.
7. Read the DTCs. Refer to DTC CHECK/CLEAR [08/2012 - ] .

   Result

   Result	Proceed to
   DTC is not output	A
   DTC P1630 is output	B

B → See step   2 

A → See step   5 

1. Replace the brake actuator assembly (skid control ECU). Refer to REMOVAL [08/2012 - ] .

NEXT: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Clear the DTCs. Refer to DTC CHECK/CLEAR [08/2012 - ] .
5. Perform the following to make sure that the DTC detection conditions are met.

   HINT: 

   If the detection conditions are not met, the malfunction cannot be detected.

   1. Drive the vehicle at a speed of 50 km/h (30 mph) or more.
   2. Turn the cruise control main switch on.
6. Enter the following menus: Powertrain / Radar Cruise / Trouble Codes.
7. Read the DTCs. Refer to DTC CHECK/CLEAR [08/2012 - ] .

   Result

   Result	Proceed to
   DTC is not output	A
   DTC P1630 is output (for 2GR-FSE)	B
   DTC P1630 is output (for 4GR-FSE)	C

B → See step   4 

C → See step   6 

A → END