DTC P0500: Vehicle Speed Sensor Malfunction: Procedure
- READ OUTPUT DTC (DTC P0500)
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Clear the DTCs. Refer to DTC CHECK/CLEAR [08/2012 - ] .
- Perform the following to make sure that the DTC detection conditions are met.
HINT:
If the detection conditions are not met, the malfunction cannot be detected.
- With the shift lever in D, drive the vehicle for more than 10 seconds when the engine coolant temperature is more than 20°C (68°F).
- Enter the following menus: Powertrain / Radar Cruise / Trouble Codes.
- Read the DTCs. Refer to DTC CHECK/CLEAR [08/2012 - ]
.
Result
Result Proceed to DTC is not output A DTC P0500 is output (for 2GR-FSE) B DTC P0500 is output (for 4GR-FSE) C
B → See step 3
C → See step 4
A → See step 2
- USE SIMULATION METHOD TO CHECK. Refer to ELECTRONIC CIRCUIT INSPECTION PROCEDURE [08/2012 - ]
- GO TO SFI SYSTEM (for 2GR-FSE). Refer to DTC P0500: Vehicle Speed Sensor "A"
- GO TO SFI SYSTEM (for 4GR-FSE). Refer to DTC P0500: Vehicle Speed Sensor "A"