VSC Buzzer Circuit: Procedure

NG → See step   6 

OK: Go to next step 

1. Turn the engine switch off.
2. Connect the Techstream to the DLC3.
3. Turn the engine switch on (IG).
4. Turn the Techstream on.
5. Enter the following menus: Chassis / ABS/VSC/TRAC / Data List.
   ABS/VSC/TRAC
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Buzzer	Buzzer/ ON or OFF	ON: Buzzer on OFF: Buzzer off	The combination meter has a built-in buzzer.

6. When performing the Buzzer Active Test, check Buzzer in the Data List. Refer to DATA LIST / ACTIVE TEST [06/2012 - ] .
   ABS/VSC/TRAC
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   Buzzer	Buzzer	Buzzer ON/OFF	The buzzer can be heard.

   RESULT
   
   

   Result		Proceed to
   Data List Display	Data List Display when Performing Active Test ON/OFF Operation
   ON	Changes between ON and OFF	A
   	Does not change between ON and OFF	B
   OFF	Changes between ON and OFF	A
   	Does not change between ON and OFF	B

B → See step   3 

A → See step   5 

1. Inspect the combination meter. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [06/2012 - ] .

NG → See step   7 

OK → See step   4