DTC C1433: Steering Angle Sensor Internal Circuit: Procedure
- CHECK DTC (CAN COMMUNICATION SYSTEM)
- Check for DTCs. Refer to DTC CHECK / CLEAR [06/2012 - ]
.RESULT
Result Proceed to CAN DTC is not output A CAN DTC is output B
B → See step 3
A: Go to next step
- Check for DTCs. Refer to DTC CHECK / CLEAR [06/2012 - ]
.
- REPLACE SPIRAL CABLE SUB-ASSEMBLY
- Replace the spiral cable sub-assembly. Refer to REMOVAL [06/2012 - ]
.NOTE:
- Do not remove the steering angle sensor from the spiral cable sub-assembly.
- When replacing the spiral cable sub-assembly, confirm that the replacement part is of the correct specification.
NEXT → END
- Replace the spiral cable sub-assembly. Refer to REMOVAL [06/2012 - ]
.
- GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING). Refer to HOW TO PROCEED WITH TROUBLESHOOTING [06/2012 - ]