DTC C1420: Acceleration Sensor Malfunction: Procedure
- CHECK DTC (CAN COMMUNICATION SYSTEM)
- Check for DTCs. Refer to DTC CHECK / CLEAR [06/2012 - ]
.RESULT
Result Proceed to CAN DTC is not output A CAN DTC is output B
B → See step 5
A: Go to next step
- Check for DTCs. Refer to DTC CHECK / CLEAR [06/2012 - ]
.
- CHECK YAW RATE AND ACCELERATION SENSOR INSTALLATION
- Check that the yaw rate and acceleration sensor is installed properly. Refer to INSTALLATION [06/2012 - ]
.
OK
The sensor is tightened to the specified torque.
The sensor is not installed at an angle.
NG → See step 4
OK → See step 3
- Check that the yaw rate and acceleration sensor is installed properly. Refer to INSTALLATION [06/2012 - ]
.
- REPLACE YAW RATE AND ACCELERATION SENSOR. Refer to REMOVAL [06/2012 - ]
- INSTALL YAW RATE AND ACCELERATION SENSOR CORRECTLY. Refer to INSTALLATION [06/2012 - ]
- GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING). Refer to HOW TO PROCEED WITH TROUBLESHOOTING [06/2012 - ]