DTC C1268: Transfer L4 Position Switch Circuit: Procedure

INSPECT TRANSFER L4 SHIFT
1. Shift the transfer to L4, and then drive the vehicle and check that there are no problems with the transfer system.
  OK
  
  There are no problems with the transfer system.
NG → See step 4

OK: Go to next step

RECONFIRM DTC

Clear the DTCs. Refer to DTC CHECK / CLEAR [06/2012 - ] .

Shift the transfer to L4, drive the vehicle, and then check for DTCs.

RESULT

Result	Proceed to
DTC is not output	A
DTC is output	B

B → See step 3

A → See step 5

REPLACE MASTER CYLINDER SOLENOID. Refer to DISASSEMBLY [06/2012 - ]
GO TO TRANSFER SYSTEM (PROBLEM SYMPTOMS TABLE). Refer to PROBLEM SYMPTOMS TABLE [06/2012 - ]
USE SIMULATION METHOD TO CHECK. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [06/2012 - ]