DTC C1420: Acceleration Sensor Malfunction: Procedure
- CHECK YAW RATE SENSOR INSTALLATION
- Check that the yaw rate sensor has been installed properly. Refer to INSTALLATION [12/2011 - ]
.
OK
The sensor is tightened to the specified torque.
The sensor is not installed in a tilted position.
HINT:
If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step. Refer to PROBLEM SYMPTOMS TABLE [12/2011 - ] .
NG → See step 3
OK → See step 2
- Check that the yaw rate sensor has been installed properly. Refer to INSTALLATION [12/2011 - ]
.
- REPLACE YAW RATE SENSOR. Refer to REMOVAL [12/2011 - ]
- INSTALL YAW RATE SENSOR CORRECTLY. Refer to INSTALLATION [12/2011 - ]