DTC C1440: Unusual Bank Angle Detected: Procedure

1. Clear the DTCs. Refer to DTC CHECK / CLEAR [06/2012 - ] .
2. Turn the engine switch off.
3. Perform a road test.
4. Check if the same DTC is output. Refer to DTC CHECK / CLEAR [06/2012 - ] .

   Result

   Result	Proceed to
   DTC C1440 is output.	A
   DTC C1440 is not output.	B
   Yaw rate and acceleration sensor DTCs are output.	C

B → END 

C → See step   3 

A: Go to next step 

1. Clear the DTCs. Refer to DTC CHECK / CLEAR [06/2012 - ] .

   HINT: 

   • If the skid control ECU (brake actuator assembly) determines that the vehicle is being driven at a steep bank angle, the skid control ECU (brake actuator assembly) stores DTC C1440 while VSC operation is temporarily disabled.
   • This is not a malfunction if the system and sensor circuits are normal and if the normal VSC operation resumes.

NEXT → END