Kick Down Switch Circuit: Procedure

1. Disconnect the kick-down switch connector.
2. Measure the resistance according to the value(s) in the table below.
   Fig 1: Identifying A61 Kick Down Switch Connector

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   A61-1 - Body ground	Always	Below 1 Ω

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: Go to next step 

1. Measure resistance according to the value(s) in the table below when kick-down switch is ON and OFF.
   Fig 2: Inspecting Kick Down Switch Assembly

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   1 - 2	Press continuously (Kick-down switch is ON)	Below 25 Ω
   	Release (Kick-down switch is OFF)	10 kΩ or higher

NG → REPLACE KICK DOWN SWITCH ASSEMBLY 

OK: Go to next step 

1. Connect the kick-down switch connector.
   Fig 3: Identifying ECM Connector

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disconnect the ECM connector.
3. Measure resistance according to the value(s) in the table below when accelerator pedal is fully depressed or not.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   A5-14 (KD) - Body ground	Fully depressed (Kick-down switch is ON)	Below 25 Ω
   	Release (Kick-down switch is OFF)	10 kΩ or higher

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → See step   4