TS and CG Terminal Circuit: Procedure

1. Disconnect the skid control ECU connector.
   Fig 1: Identifying TS Of DLC3 Terminal Connectors

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   A62-33 (TS) - J21-12 (TS)	Always	Below 1 Ω
   A62-33 (TS) - Body ground	Always	10 kΩ or higher

   TEXT IN ILLUSTRATION
   
   

   *1	Front view of wire harness connector (to Skid Control ECU)
   *2	DLC3

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: Go to next step 

1. Measure the resistance according to the value(s) in the table below.
   Fig 2: Identifying J21 Connector Terminals

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   J21-4 (CG) - Body ground	Always	Below 1 Ω

   TEXT IN ILLUSTRATION
   
   

   *1

   DLC3

   HINT: 

   If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the part. Refer to PROBLEM SYMPTOMS TABLE .

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → See step   3