Pattern Select Switch: Inspection: Inspection

INSPECT NO. 1 PATTERN SELECT SWITCH ASSEMBLY

Measure the resistance according to the value(s) in the table below.

Fig 1: Identifying No. 1 Pattern Select Switch Assembly

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

TEXT IN ILLUSTRATION

*a	Component without harness connected (No. 1 Pattern Select Switch Assembly)

STANDARD RESISTANCE

Tester Connection	Switch Condition	Specified Condition
3 - 7	Pattern select switch in the PWR position	Below 1 Ω
3 - 7	Pattern select switch in the NORM position	10 kΩ or higher
1 - 3	Pattern select switch pressed and held in the SNOW position	Below 1 Ω
1 - 3	Pattern select switch not pressed and held in the SNOW position	10 kΩ or higher

If the resistance value is not as specified, replace the No. 1 pattern select switch assembly.