DTC P0575: Cruise Control Input Circuit: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Clear the DTCs. Refer to DTC CHECK / CLEAR .
5. Turn the Techstream off.
6. Turn the engine switch off.
7. Disconnect the Techstream.
8. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
9. Connect the cable to the negative (-) battery terminal.
10. Connect the Techstream to the DLC3.
11. Turn the engine switch on (IG).
12. Turn the Techstream on.
13. Enter the following menus: Powertrain / Radar Cruise / Trouble Codes.
14. Read the DTCs. Refer to DTC CHECK / CLEAR .
    RESULT
    
    

    Result	Proceed to
    DTC is not output	A
    DTC P0575 is output (for 2GR-FSE)	B
    DTC P0575 is output (for 4GR-FSE)	C

B → See step   3 

C → See step   4 

A → See step   2