Cruise Main Indicator Light Circuit: Procedure
- PERFORM ACTIVE TEST USING TECHSTREAM
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Body Electrical / Combination Meter / Active Test.
- Check the CRUISE main indicator light by performing the Active Test.COMBINATION METER
Techstream Display Test Part Control Range Diagnostic Note Indicat. Lamp Cruise CRUISE main indicator light BLINK / OFF - OK
Indicator light blinks/goes off.
NG → See step 4
OK: Go to next step
- READ VALUE USING TECHSTREAM
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Powertrain / Cruise Control / Data List.
- Check the Data List for proper functioning of the CRUISE main indicator light.CRUISE CONTROL
Tester Display Measurement Item/Range Normal Condition Diagnostic Note CCS Indicator M-CPU Cruise indicator signal (Main CPU) / ON or OFF ON: "CRUISE" on
OFF: "CRUISE" off- OK
When the cruise control main switch is operated, the display changes as shown above.
Result
Result Proceed to OK A NG (2GR-FSE) B NG (4GR-FSE) C
B → See step 5
C → See step 6
A → See step 3
- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to PROBLEM SYMPTOMS TABLE
- REPLACE COMBINATION METER ASSEMBLY. Refer to REMOVAL
- REPLACE ECM (2GR-FSE). Refer to REMOVAL
- REPLACE ECM (4GR-FSE). Refer to REMOVAL