DTC P0500: Vehicle Speed Sensor Malfunction: Procedure

CHECK FOR DTC
1. Clear the DTCs. Refer to DTC CHECK / CLEAR .
2. Perform the following to make sure the DTC detection conditions are met.
  HINT:
  
  If the detection conditions are not met, the system cannot detect the malfunction.
  1. Drive the vehicle for more than 10 seconds when the engine coolant temperature is more than 20°C (68°F).
3. Check for DTCs. Refer to DTC CHECK / CLEAR .
  OK
  
  DTC P0500 is not output.
NG → See step 3

OK → See step 2
USE SIMULATION METHOD TO CHECK. Refer to HOW TO PROCEED WITH TROUBLESHOOTING
GO TO SFI SYSTEM. Refer to DTC P0500: Vehicle Speed Sensor "A"