Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Lexus >> 2011 >> IS F >> Repair and Diagnosis >> Engine Mechanical >> Fuel System >> Fuel System (Service Information) >> Fuel Sender Gauge Assembly >> Inspection >> Inspection

Fuel Sender Gauge Assembly: Inspection: Inspection

  1. INSPECT FUEL SENDER GAUGE ASSEMBLY 
    1. Disconnect the fuel sender gauge connector.
      Fig 1: Identifying Fuel Sender Gauge Connector Terminals
      GTY148914Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Inspect the fuel sender gauge assembly.
      1. Remove the fuel sender gauge assembly.
      2. Check that the float moves smoothly between F and E.
      3. Measure the resistance between terminals 2 (S) and 1 (FE) of the connector according to the value(s) in the table below.

        Standard Resistance

        Float Level Resistance (Ω)
        F 6.5 to 8.5
        Between E and F 6.5 to 229.6 (Gradually changes)
        E 224.6 to 229.6

        HINT: 

        If the value is not as specified, replace the fuel sender gauge assembly LH.

  2. INSPECT FUEL SENDER GAUGE 
    1. Disconnect the fuel sender gauge connector.
      Fig 2: Identifying Fuel Sender Gauge Connector Terminals
      GTY135883Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Inspect the fuel sender gauge assembly.
      1. Remove the fuel sender gauge assembly.
      2. Check that the float moves smoothly between F and E.
      3. Measure the resistance between terminals 1 (FS) and 2 (E) according to the value(s) in the table below.

        Standard Resistance

        Float Level Resistance (Ω)
        F 6.5 to 8.5
        Between E and F 6.5 to 184.9 (Gradually changes)
        E 180.9 to 184.9

        HINT: 

        If the result is not as specified, replace the fuel sender gauge assembly RH.

scientia non olet · About Mike's Workshop Manuals