Millimeter Wave Radar Sensor: Installation: Installation
WARNING: This page is about a different car, the 2011 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY
- Tighten the 3 bolts on the millimeter wave radar sensor assembly.
- Install the millimeter wave radar sensor with the 3 bolts as shown in the illustration.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf)
- Connect the connector.
- INSTALL FRONT BUMPER ASSEMBLY . Refer to INSTALLATION - Step 1
- INSTALL RADIATOR GRILLE PROTECTOR . Refer to INSTALLATION - Step 2
- INSTALL COOL AIR INTAKE DUCT SEAL . Refer to INSTALLATION - Step 3
- ADJUST MILLIMETER WAVE RADAR SENSOR ASSEMBLY See step 1
- ADD WASHER FLUID (w/ Headlight Cleaner System) . Refer to INSTALLATION - Step 3
- ADJUST FOG LIGHT AIMING
Refer to ADJUSTMENT