DCM(Telematics Transceiver): Installation: Installation

WARNING: This page is about a different car, the 2011 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL DCM (TELEMATICS TRANSCEIVER)
INSTALL NO. 1 TELEPHONE BRACKET
1. Install the No. 1 telephone bracket with the 2 screws.
  
  Fig 1: Identifying No. 1 Telephone Bracket Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 2 TELEPHONE BRACKET
1. Install the No. 2 telephone bracket with the 2 screws.
  
  Fig 2: Identifying No. 2 Telephone Bracket Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL DCM (TELEMATICS TRANSCEIVER) WITH BRACKET
1. Install the DCM (telematics transceiver) with bracket with the bolt and nut.
  
  Fig 3: Identifying DCM (Telematics Transceiver) Bolt, Nut & Bracket
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  Bolt
  
  Torque: 12 N*m (122 kgf*cm, 9 ft.*lbf)
2. Engage the clamp.
  
  Fig 4: Identifying Connectors And Clamp
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect each connector.
INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY . Refer to INSTALLATION - Step 14
INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY . Refer to INSTALLATION - Step 1
INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY . Refer to INSTALLATION - Step 16
INSTALL SIDE INSTRUMENT PANEL RH . Refer to INSTALLATION - Step 17
INSTALL FRONT DOOR OPENING TRIM COVER RH
HINT:

Use the same procedure for the RH side and LH side. Refer to INSTALLATION - Step 79 .
INSTALL FRONT DOOR SCUFF PLATE RH
HINT:

Use the same procedure for the RH side and LH side. Refer to INSTALLATION - Step 81 .
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
INSPECT SRS WARNING LIGHT
1. Inspect the SRS warning light. Refer to DIAGNOSIS SYSTEM .
DCM ACTIVATION
HINT:

When replacing the DCM (telematics transceiver), perform the vehicle contract setting. Refer to DCM ACTIVATION .