How To Proceed With Troubleshooting

HINT: 

• Use the following procedures to troubleshoot the power mirror control system.
• *: Use Techstream.

1. VEHICLE BROUGHT TO WORKSHOP 

   NEXT: Go to next step 

2. INSPECT BATTERY VOLTAGE 

   Standard voltage

   11 to 14 V

   If the voltage is below 11 V, recharge or replace the battery before proceeding.

   NEXT: Go to next step 

3. INSPECT COMMUNICATION FUNCTION OF MULTIPLEX COMMUNICATION SYSTEM (BEAN)* 
   1. Use Techstream to check if the Multiplex Communication System (MPX) is functioning normally.
      RESULT:
      
      

      Result	Proceed to
      MPX DTC is not output	A
      MPX DTC is output	B

      B → Go to MULTIPLEX COMMUNICATION SYSTEM 

      A: Go to next step 

4. PROBLEM SYMPTOMS TABLE 
   RESULT:
   
   

   Result	Proceed to
   Fault is not listed in problem symptoms table	A
   Fault is listed in problem symptoms table	B

   B → Go to step 6 

   A: Go to next step 

5. OVERALL ANALYSIS AND TROUBLESHOOTING* 
   1. DATA LIST / ACTIVE TEST. Refer to DATA LIST / ACTIVE TEST 
   2. Terminals of ECU. Refer to TERMINALS OF ECU 
   3. On-vehicle Inspection See step  1

      NEXT: Go to next step 

6. ADJUST, REPAIR OR REPLACE 

   NEXT: Go to next step 

7. CONFIRMATION TEST 

   NEXT → END