DTC P2532-772: Ignition Switch Run Position Circuit High: Procedure

1. Disconnect connector A20 from the power management control ECU.
   Fig 1: Identifying A20 Connector Terminal

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   TEXT IN ILLUSTRATION
   
   

   *a	Rear view of wire harness connector (to Power Management Control ECU)

2. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Switch Condition	Specified Condition
   A20-1 (IG2) - Body ground	Power switch off	Below 1 V
   A20-2 (IG2D) - Body ground	Power switch off	Below 1 V

   RESULT
   
   

   Result	Proceed to
   NG	A
   OK	B

3. Connect the power management control ECU connector.

B → See step   3 

A: Go to next step 

1. Disconnect connector A20 from the power management control ECU.
2. Remove the No. 2 integration relay from the engine room junction block assembly.
   Fig 2: Identifying A20 Connector Terminal

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   TEXT IN ILLUSTRATION
   
   

   *a	Rear view of wire harness connector (to Power Management Control ECU)

3. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Switch Condition	Specified Condition
   A20-1 (IG2) - Body ground	Power switch off	Below 1 V
   A20-2 (IG2D) - Body ground	Power switch off	Below 1 V

4. Install the No. 2 integration relay.
5. Connect the power management control ECU connector.

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → REPLACE NO. 2 INTEGRATION RELAY