Yaw Rate And Acceleration Sensor: Installation: Installation

WARNING: This page is about a different car, the 2010 Lexus GS 460 and 2010 Lexus GS 350. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL YAW RATE SENSOR
1. Connect the yaw rate sensor connector.
  
  Fig 1: Identifying Yaw Rate Sensor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the yaw rate sensor with the 2 bolts.
  Torque: 15 N*m (153 kgf*cm, 11 ft.*lbf)
  NOTE:
  - Do not damage the yaw rate sensor.
  - Make sure that the yaw rate sensor is installed securely.
3. Install the 2 wire harness clamps.
INSTALL NO. 1 CONSOLE BOX DUCT
1. Install the No. 1 console box duct with the clip.
  
  Fig 2: Identifying No. 1 Console Box Duct
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 2 CONSOLE BOX DUCT
1. Install the No. 2 console box duct with the 2 clips.
  
  Fig 3: Identifying Console Box No. 2 Duct Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL CONSOLE BOX . Refer to INSTALLATION - Step 18
INSTALL CONSOLE BOX REGISTER ASSEMBLY . Refer to INSTALLATION - Step 19
INSTALL INSTRUMENT PANEL FINISH PANEL END LH . Refer to INSTALLATION - Step 21
INSTALL INSTRUMENT PANEL FINISH PANEL END RH . Refer to INSTALLATION - Step 22
INSTALL CONSOLE BOX PLATE . Refer to INSTALLATION - Step 20
INSTALL FRONT CONSOLE UPPER PANEL ASSEMBLY . Refer to INSTALLATION - Step 23
INSTALL CONSOLE UPPER PANEL GARNISH FRONT . Refer to INSTALLATION - Step 24
PERFORM YAW RATE SENSOR ZERO POINT CALIBRATION
HINT:
- for 2GR-FSE. Refer to CALIBRATION
- for 1UR-FSE. Refer to CALIBRATION
INSPECT VSC SENSOR SIGNAL
HINT:
- for 2GR-FSE. Refer to TEST MODE PROCEDURE
- for 1UR-FSE. Refer to TEST MODE PROCEDURE