Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Lexus >> 2010 >> HS 250h >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Entertainment Systems >> Wide View Front Monitor System (Diagnostics - Introduction) >> Wide View Front Monitor System >> DTC Check / Clear >> DTC Check / Clear

DTC Check / Clear

  1. CHECK DTC 
    1. Connect the Techstream to the DLC3.
    2. Turn the power switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Chassis / Parking Assist Monitor System / Trouble Codes.
    5. Check for DTCs. Refer toDIAGNOSTIC TROUBLE CODE CHART .

      HINT: 

      The parking assist ECU may store the DTCs of the following system. If DTCs other than those specified in Diagnostic Trouble Code Chart of the wide view front monitor system are output, refer to DIAGNOSTIC TROUBLE CODE CHART Diagnostic Trouble Code Chart for the applicable system.

      System Proceed to
      Rear view monitor system (w/ wide view front monitor system) Refer toDIAGNOSTIC TROUBLE CODE CHART
  2. CLEAR DTC 
    1. Connect the Techstream to the DLC3.
    2. Turn the power switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Chassis / Parking Assist Monitor System / Trouble Codes.
    5. Clear the DTCs.
scientia non olet · About Mike's Workshop Manuals