Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Lexus >> 2010 >> GS 450h >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Control System (Diagnostic Codes (P0365-U0293) & Circuit Tests) >> SFI System >> DTC P0607: Control Module Performance >> Procedure

DTC P0607: Control Module Performance: Procedure

  1. CHECK WHETHER DTC OUTPUT RECURS (IN ADDITION TO DTC P0607) 
    1. Connect the Techstream to the DLC3.
    2. Turn the power switch on (IG).
    3. Turn the Techstream on.
    4. Clear the DTC. Refer toDTC CHECK / CLEAR .
    5. Turn the power switch off.
    6. Disconnect the battery negative terminal and wait for 1 minute.
    7. Connect the battery negative terminal.
    8. Turn the power switch on (IG).
    9. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
    10. Read the DTCs.

      Result

      Display (DTC output) Proceed to
      P0607 A
      No output DTC B

    B → See step   2 

    A → See step   3 

  2. CHECK FOR INTERMITTENT PROBLEMS. Refer to CHECK FOR INTERMITTENT PROBLEMS 
  3. REPLACE ECM. Refer to REMOVAL 
scientia non olet · About Mike's Workshop Manuals