TC and CG Terminal Circuit: Procedure

Fig 1: Identifying DLC3 Connector Terminal

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Turn the ignition switch ON.
2. Measure the voltage of the DLC3.

   Standard voltage

   Tester Connection	Specified Condition
   D1-13 (TC) - Body ground	10 to 14 V

NG → See step   3 

OK: Go to next step 

1. Check the DTC. Refer to DTC CHECK / CLEAR .
   RESULT
   
   

   Result	Proceed to
   DTC is not output	A
   DTC is output	B

B → REPAIR CIRCUITS INDICATED BY OUTPUT DTCS 

A → REPLACE SKID CONTROL ECU 

Fig 2: Checking Wire Harness (Skid Control ECU - ECM)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Disconnect the E6 ECM connector.
2. Measure the resistance of the wire harness side connectors.

   Standard resistance

   Tester Connection	Specified Condition
   D1-13 (TC) - E5-3 (TC)	Below 1 Ω
   D1-13 (TC) - Body ground	1 MΩ or higher

NG → REPAIR OR REPLACE HARNESS AND CONNECTOR 

OK: Go to next step 

Fig 3: Identifying DLC3 Connector Terminals

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Measure the resistance of the wire harness side connector.

   Standard resistance

   Tester Connection	Specified Condition
   D1-4 (CG) - Body ground	Below 1 Ω

NG → REPAIR OR REPLACE HARNESS AND CONNECTOR 

OK: Go to next step 

1. Check the DTC. Refer to DTC CHECK / CLEAR .
   RESULT
   
   

   Result	Proceed to
   DTC is not output	A
   DTC is output	B

B → REPAIR CIRCUITS INDICATED BY OUTPUT DTCS 

A → REPLACE SKID CONTROL ECU