How To Proceed With Troubleshooting

HINT: 

• Use these procedures to troubleshoot the active stabilizer suspension system.
• *: Using the Techstream.

1. VEHICLE BROUGHT TO WORKSHOP 

   NEXT: Go to next step 

2. INSPECT AUXILIARY BATTERY VOLTAGE 

   Standard voltage

   11 to 14 V

   If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding.

   NEXT: Go to next step 

3. CHECK FOR DTC (ALL)* 
   1. Check for all DTCs.
      RESULT
      
      

      Result	Proceed to
      DTC is output.	A
      CAN communication system DTC is output.	B
      DTC is not output.	C

      If a CAN communication malfunction code is output, troubleshoot that code before performing repairs on this system.

      B → GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING). Refer to  HOW TO PROCEED WITH TROUBLESHOOTING 

      C → USE SIMULATION METHOD TO CHECK. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING 

      A: Go to next step 

4. REPAIR OR REPLACE 
   1. Before performing repairs or replacement, refer to PRECAUTION. Refer to PRECAUTION .
   2. Refer to the DIAGNOSTIC TROUBLE CODE CHART and perform repairs. Refer to DIAGNOSTIC TROUBLE CODE CHART .

      NEXT: Go to next step 

5. CONFIRMATION TEST* 
   1. Perform the OPERATION CHECK. Refer to OPERATION CHECK .

      NEXT → END