Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Lexus >> 2009 >> LS 600hL >> Repair and Diagnosis >> External Pages >> Different car >> Section 42 (Audio/Visual) >> Audio And Visual System >> Sound Signal Circuit between Radio Receiver and Stereo Component Amplifier >> Inspection Procedure

Inspection Procedure

WARNING: This page is about a different car, the 2008 Lexus LS 600hL. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - STEREO COMPONENT AMPLIFIER) 
    1. Disconnect the L51 receiver connector.
    2. Disconnect the R34 amplifier connector.
    3. Measure the resistance according to the value(s) in the table below

      Standard resistance 

      TESTER CONNECTION SPECIFIED CONDITION CHART

      Tester Connection Condition Specified Condition
      R34-3 (L+) - L51-9 (L+) Always Below 1 Ω
      R34-2 (L-) - L51-19 (L-)
      R34-5 (R+) - L51-8 (R+)
      R34-4 (R-) - L51-18 (R+)
      R34-3 (L+) - Body ground Always 10 kΩ or higher
      R34-2 (L-) - Body ground
      R34-5 (R+) - Body ground
      R34-4 (R-) - Body ground
      Fig 1: Checking Harness And Connector (Radio Receiver - Stereo Component Amplifier)
      G05783499Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

    OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE  (See PROBLEM SYMPTOMS TABLE  )