Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Lexus >> 2009 >> LS 600hL >> Repair and Diagnosis >> External Pages >> Different car >> Section 177 (Engine Control System - Circuit Tests, Component Removal, Inspection & Installation) >> VVT Sensor >> Removal

VVT Sensor: Removal

WARNING: This page is about a different car, the 2008 Lexus LS 600hL. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

When viewed from the rear of the engine assembly, Bank 1 is on the left side and Bank 2 is on the right side.

  1. REMOVE V-BANK COVER SUB-ASSEMBLY  (See REMOVAL )
  2. REMOVE AIR CLEANER INLET COVER SUB-ASSEMBLY  (See REMOVAL )
  3. REMOVE NO. 1 AIR CLEANER INLET  (See REMOVAL )
  4. REMOVE AIR CLEANER ASSEMBLY LH  (See REMOVAL )
  5. REMOVE AIR CLEANER ASSEMBLY RH  (See REMOVAL )
  6. REMOVE VVT SENSOR 
    1. Disconnect the 4 sensor connectors.
      2. Fig 1: Locating VVT Sensor Connector
      G05771252Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 4 bolts and 4 sensors.
scientia non olet · About Mike's Workshop Manuals