Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Lexus >> 2009 >> LS 600hL >> Repair and Diagnosis >> External Pages >> Different car >> Section 177 (Engine Control System - Circuit Tests, Component Removal, Inspection & Installation) >> VVT Sensor >> Installation

VVT Sensor: Installation

WARNING: This page is about a different car, the 2008 Lexus LS 600hL. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

When viewed from the rear of the engine assembly, Bank 1 is on the left side and Bank 2 is on the right side.

  1. INSTALL VVT SENSOR 
    1. Install the 4 sensors with the 4 bolts.

      Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

    2. Connect the 4 sensor connectors
      3. Fig 1: Locating VVT Sensor Connector
      G05771252Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL AIR CLEANER ASSEMBLY RH  (See INSTALLATION )
  3. INSTALL AIR CLEANER ASSEMBLY LH  (See INSTALLATION )
  4. INSTALL NO. 1 AIR CLEANER INLET  (See INSTALLATION )
  5. INSTALL AIR CLEANER INLET COVER SUB-ASSEMBLY  (See INSTALLATION )
  6. INSTALL V-BANK COVER SUB-ASSEMBLY  (See INSTALLATION )
scientia non olet · About Mike's Workshop Manuals