Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Lexus >> 2009 >> LS 600hL >> Repair and Diagnosis >> External Pages >> Different car >> Section 177 (Engine Control System - Circuit Tests, Component Removal, Inspection & Installation) >> Engine Coolant Temperature Sensor >> Removal

Engine Coolant Temperature Sensor: Removal

WARNING: This page is about a different car, the 2008 Lexus LS 600hL. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE V-BANK COVER SUB-ASSEMBLY  (See REMOVAL )
  2. REMOVE AIR CLEANER INLET COVER SUB-ASSEMBLY  (See REMOVAL )
  3. REMOVE NO. 1 AIR CLEANER INLET  (See REMOVAL )
  4. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH  (See REMOVAL )
  5. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH  (See REMOVAL )
  6. REMOVE NO. 1 ENGINE UNDER COVER  (See REMOVAL )
  7. DRAIN ENGINE COOLANT  (See REPLACEMENT )
  8. REMOVE ENGINE COOLANT TEMPERATURE SENSOR 
    1. Disconnect the sensor connector.
      2. Fig 1: Locating Engine Coolant Temperature Sensor
      G04943082Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the sensor.
    3. Remove the gasket from the sensor.
scientia non olet · About Mike's Workshop Manuals