Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Lexus >> 2009 >> LS 600hL >> Repair and Diagnosis >> External Pages >> Different car >> Section 177 (Engine Control System - Circuit Tests, Component Removal, Inspection & Installation) >> Engine Coolant Temperature Sensor >> Installation

Engine Coolant Temperature Sensor: Installation

WARNING: This page is about a different car, the 2008 Lexus LS 600hL. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR 
    1. Install a new gasket to the sensor.
    2. Install the sensor.

      Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf) 

      Fig 1: Locating Engine Coolant Temperature Sensor
      G04943082Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Connect the sensor connector.
  2. ADD ENGINE COOLANT  (See REPLACEMENT )
  3. INSPECT FOR COOLANT LEAK  (See ON-VEHICLE INSPECTION )
  4. INSTALL NO. 1 ENGINE UNDER COVER  (See INSTALLATION )
  5. INSTALL FRONT WHEEL OPENING EXTENSION PAD LH  (See INSTALLATION )
  6. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH  (See INSTALLATION )
  7. INSTALL NO. 1 AIR CLEANER INLET  (See INSTALLATION )
  8. INSTALL AIR CLEANER INLET COVER SUB-ASSEMBLY  (See INSTALLATION )
  9. INSTALL V-BANK COVER SUB-ASSEMBLY  (See INSTALLATION )
scientia non olet · About Mike's Workshop Manuals