Inspection Procedure

1. Use the Data List to check if the clearance sonar main switch is functioning properly.

   Intuitive P/A 

   INTUITIVE P/A DATA LIST
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Main Switch	Clearance sonar main switch/ OFF or ON	OFF: Clearance sonar main switch OFF ON: Clearance sonar main switch ON	-

   NG: Go to step 2 

   OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE  (See PROBLEM SYMPTOMS TABLE )

1. Remove the D-IG1-1 and D MPX-B 1 fuses from driver side junction block.
2. Measure the resistance according to the value (s) in the table below.

   Standard resistance 

   RESISTANCE SPECIFIED CONDITIONS
   
   

   Tester Connection	Condition	Specified Condition
   D-IG1-1 fuse	Always	Below 1 Ω
   D MPX-B 1 fuse	Always	Below 1 Ω

   NG: REPLACE FUSE 

   OK: Go to Next Step 

1. Disconnect the switch connector.
2. Measure the resistance according to the value (s) in the table below.

   Standard resistance 

   RESISTANCE SPECIFIED CONDITIONS
   
   

   Tester Connection	Condition	Specified Condition
   L6-1 (E) - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the value (s) in the table below.

   Standard voltage 

   VOLTAGE SPECIFIED CONDITIONS
   
   

   Tester Connection	Condition	Specified Condition
   L6-12 (B) - Body ground	Always	11 to 14 V
   L6-11 (IG) - Body ground	Engine switch on (IG)	11 to 14 V

Fig 1: Identifying L6 Outer Mirror Switch Connector Terminals

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE  (See PROBLEM SYMPTOMS TABLE )